Vanquish Hurtz Dig V2 Red

Vanquish Products Aluminum Hurtz Shifter 3 Position Dig for Axial 3-Gear Transmissions.<br><br>Vanquish Products Aluminum Hurtz Shifter 3 Position Dig for Axial 3-Gear Transmissions.<br>Updated dig unit was designed to increase the capability of your vehicle while maintaining maximum strength<br>Compatible with Axial SCX10, SCX10-II RTR and AX10. May also be used in Wraith by changing the transmission case<br>Rear output is bearing supported for better driveline efficiency and cross drilled to work with thru pin style driveshafts<br>Rear output does not slide in and out, so driveshaft length is easier to manage<br>Servo mount is attached to dig case for simple installation<br>All drive parts are made from high quality and chromoly steel<br>Total shifter travel needed to shift to all three positions is 0.73 inches, a 24mm servo horn is recommended<br>Servo mount can use most standard size servos*<br>The lever design of the shifter means that you do not need an expensive servo to reliably operate this unit**<br>V2 design works with stock Axial 3-gear transmission cases as well as any Vanquish Products SCX10 transmission housing***<br>* Servo case designs and offsets vary by manufacturer, Futaba, Hitec and Tactic servos have been tested to fit but not every model can be verified<br><br>** A radio with an open auxiliary channel and programmable end points is needed to ensure that the dig unit works properly and that your servo will not overheat<br><br>*** The Hurtz dig will mount onto any Axial 3 gear transmission case that uses a bolt on metal motor plate. Does not work with LCX Grey Axial transmission housing.<br>